Connections; Location And Assembly - Ecler IC SB10 Notice D'emploi

4. CONNECTIONS

The connection terminals are of spring
clamp type for peeled cable. Once they are
connected, all you have to do is choose the unit's
power and mode of operation using a simple
screwdriver. Always pay attention to the polarity.
The IC SB10 is delivered with the switch in the 100V/70V position. If you
accidentally hook it up to a low-impedance system, no damage will be done to the speaker,
but it will perform far under its real capabilities. If you accidentally connect the speaker to a
100V/70V network in the 8Ω position, serious damage will be caused to the speaker.
It is easy to install the IC SB10 with the four revolving fasteners incorporated. For more
information on how to install the IC SB10, please see section 5 of this manual.

5. LOCATION AND ASSEMBLY

To install this product correctly, you must be prepared to cut circular holes where you would
like to place the speakers and have the wiring necessary for each unit.
In order to install the speakers correctly:
1. Remove the protective grating from the speaker using the hook provided in the packaging.
2. Cut a circular hole in the false ceiling.
A template for cutting/painting is included with each unit to simplify this process. Once the
unit is separated into two parts, the outside part can be used as a template to make the hole in the
ceiling, and the inner disk can be used to protect the speaker cone if you would like to paint the
plastic another colour.
3. Use the clamps to connect the unit to the wiring of the system where the speaker is being
installed.
4. Place the speaker in the newly cut hole. Hold it in place with your hand and push it into
place, all the while making sure that the 4 revolving fasteners are drawn back.
5. Press each of the 4 screws that are accessible from the front side of the speaker. The
speaker is now fixed in its final position.
6. Reattach the protective grille.
Each IC SB10 speaker comes with a set of accessories that make it easy to install in drop
ceilings, resulting in an installation that is even more solid and reliable.
- A C-shaped metal ring.
- Two brackets especially designed for use in 600mm ceiling grids.
5