Ferm CSM1038 Traduction De La Notice Originale page 7

1 60HSS blade for aluminium and very fine
wood and plastics
1 Dust extraction hose
2 Allen key
1 Safety instructions
1 Instruction manual
1 Warranty card
Check the machine, loose parts and accessories
for transport damage.
Product information
Fig.1
1. Protective cover
2. Guard lock
3. Saw depth limiter
4. On/Off switch
5. Handgrip
6. Rear ventilation hole
7. Front ventilation hole
8. Dust extraction pipe
9. Depth indicator
10. Sawblade
11. Length indicator
12. Laser
13. Laser switch
2. safety instructions
Explanation of symbols
Denotes risk of personal injury, loss of
life or damage to the tool in case of non­
observance of the instructions in this
manual
Indicates the presence of an electrical
voltage
Keep bystanders away
Wear eye protection
Wear ear protection
Wear a dust mask protection
Ferm
Caution: Laser beam! Do not look directly
into the laser beam. Do not point the
laser beam at humans or animals
Danger
a) Keep hands away from cutting area and the
blade. Keep your second hand on auxiliary
handle, or motor housing. If both hands are
holding the saw, they cannot be cut by the
blade.
b) Do not reach underneath the workpiece.
The guard cannot protect you from the blade
below the workpiece.
c) Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade
teeth should be visible below the workpiece.
d) Never hold piece being cut in your hands or
across your leg. Secure the workpiece to a
stable platform. It is important to support the
work properly to minimize body exposure,
blade binding, or loss of control.
e) Hold power tool by insulated gripping surfaces
when performing an operation where the
cutting tool may contact hidden wiring or its
own cord. Contact with a "live" wire will also
make exposed metal parts of the power tool
"live" and shock the operator.
f) When ripping always use a rip fence or
straight edge guide. This improves the
accuracy of cut and reduces the chance of
blade binding.
g) Always use blades with correct size and
shape (diamond versus round) of arbour
holes. Blades that do not match the mounting
hardware of the saw will run eccentrically,
causing loss of control.
h) Never use damaged or incorrect blade
washers or bolt. The blade washers and
bolt were specially designed for your saw,
for optimum performance and safety of
operation.
Causes and operator prevention of kickback
• Kickback is a sudden reaction to a pinched,
bound or misaligned saw blade, causing an
uncontrolled saw to lift up and out of the
workpiece toward the operator;
• When the blade is pinched or bound tightly by
the kerf closing down, the blade stalls and the
motor reaction drives the unit rapidly back
toward the operator;
• If the blade becomes twisted or misaligned in
the cut, the teeth at the back edge of the blade
EN
7