Publicité
Les langues disponibles
Les langues disponibles
B
C
25mm approx.
C
D
F
ME0118 issue 2
Fitting the Bathing Cushion in the bath
•
A
•
1
•
2
•
•
3
Connecting the air hose and hand control
•
E
•
•
4
Pass the air hose through the loop in the corner
of the backrest (A fig.1), on the side that you
propose getting into and out of the bath. The
air inlet valve (B) can be rotated, allowing the
hose to be led to the appropriate corner.
Fold the backrest over onto the seat as indicated
in fig. 2. Lightly place the deflated Bathing
Cushion in the middle of the empty bath with
the 'handle' (C) aligned with the centre of the
bath.
Hold the 'handle' and pull the Bathing Cushion
towards the slope of the bath until there is a
gap of approximately 25mm between the bath
slope and 'handle' (C figs. 2 & 3).
Press all four suction cups down and check
that they are securely stuck to the bath. Wet
them to help them stick if necessary.
Fold the backrest out so that it rests on
slope of the bath.
Select the 'Normal' Air Flow using the switch
on the underside of the Airflo compressor.
Normal
WARNING:
DO NOT operate the Normal/
High air flow switch while the compressor is
running.
Connect the air hose from the Bathing Cushion
to the Airflo air outlet socket (D fig. 4).
Connect the Push Button Hand Control (
the socket (F).
the
High
E) to
3
Publicité
