NUKI SMART LOCK 2.0 Mode D'emploi page 9

Assembly and installation
Information on assembly can be found in the
enclosed installation instructions.
To use the adhesive pad (B), the surface must be
cleaned (with residue-free cleaning agents) and
free of any grease.
If your surface is made of materials other than
metal or similarly smooth surfaces, please contact
our customer service.
Safety instructions
The following safety and hazard instruc-
tions not only serve to protect the device,
they also prevent personal injury. Please
read through the instructions carefully.
The Nuki Smart Lock 2.0 may fail due to technical
malfunctions and thus be unable to open the door.
Always carry the key to the lock with you or leave
it in an accessible place so that the door can be
opened manually in the event of an error.
Improper use of the device might result in damage.
Do not expose the device to extreme heat or cold,
direct sunlight, open flames or other extreme
conditions.
Do not short-circuit the batteries! Do not throw
the batteries into an open fire. Danger of explosion!
EN
7