iwc Portofino Automatic 34 Mode D'emploi page 23

to the desired length. When closing the locking lever please ensure that the stop pins engage in the
lower notches (2) on the bracelet.
Important: Always ensure that the locking lever on the clamp fastener is firmly closed to prevent the
bracelet from slipping out unintentionally.
SIZING THE MIL ANAISE MESH BR ACELET
Lay the bracelet with its top surface on a firm base with the clasp fully
open. Located beneath the outer side of the clasp is the clamp fastener
that holds the bracelet in position. The locking lever on the clamp fastener
(1) can be opened simply by inserting the special tool supplied with the
watch into one of the two boreholes and lifting the locking lever. After
opening, the locking lever should form a right angle to the bracelet. The
bracelet can now be moved easily inside the clasp and adjusted in stages
A metal loop (3) is available to secure the loose end of the bracelet in
position. This is infinitely adjustable and can be moved effortlessly to the
desired position.
PORTOFINO AUTOMATIC 34
— 2 3 —