Overmax X-Monster 3.1 Manuel De L'utilisateur page 15

HOW TO CHARGE CAR BATTERY
1.
Switch the car off.
2.
Connect the charging cable to USB port in the PC or USB feeder. Next,
connect the battery to the charging cable. When charging, green LED
will flash.
3.
Connect the battery to the charging cable.
4.
When the battery is full, green LED will be on continuously. After char-
ging, disconnect the battery from the charging cable.
NOTE After using in the car, wait 10-15 minutes before you start charging
charger parameters: 5V ⎓ 2A .
the battery. Do not leave the charging battery unattended. Recommended
HOW TO USE
1.
Move the car switch into ON.
2.
Move the controller switch into ON. The power LED will start flashing.
Wait about 15 seconds until the controller has connected with the car.
The LED will be on continuously.
NOTE! Always switch the car on in the first place. Otherwise the controller
may have difficulties in connecting with the car.
3.
To move forward, move the choke valve to the back. The stronger you
move the valve, the higher the speed of the car. Slide the choke valve to
the front to stop and reverse.
EN