Ramiaudio AUF 500 Manuel Utilisateur page 19

FRONT PANEL
CANAL B
Channel A is intend to spare modulation. (Pub, jingle, identification, main message ).
7 )
Warning, Channel B enabled.
8 )
Dip-switch to set input gain. ( Ranges from -12 dB to +12 dB)
Ex : 0 dB :
9 )
Key to select the input gain sign.
Green on : Sign + enabled (gain from 0to +12 dB).
Red on :
10)
Dip-switch to set the channel B rising time (fall over from channel B to channel A).
Settable from 0 to 3,75 secondes. Each switch has its own duration in seconde, enabled
when down.
Ex : 0 s :
11)
Dip-switch to set the channel B falling time (fall over from channel A to channel B).
Settable from 0 to 3,75 secondes. Each switch has its own duration in seconde, enabled
when down.
12)
Dip-switch to set the delay to fall over from B to A when B is missing. Settable from 0 to 7,5s.
Each switch has its own duration in seconde, enabled when down.
Mind : this setting should be short enough, to avoid silence at the end of channel B signal,
but not too much, to avoid unwanted return of channel A (during channel A signal short
silences)
Ex : 0,5 s :
13)
Dip-switch to set the channel B level threshold ( Ranges from -36 dBFs to 0 dBFs). Each
switch has its own value in dBFs, enabled when down.
Mind : this setting should be accurate enough to take in account low level parts of the
signal, but not too much to avoid unwanted fall over on back ground noise or
interferences. This setting is enabled only in automatic, automatic or / and manual
modes.
Rami - AUF 500
(dB)
4 1
5 2
1 2 3 4
on
-
Sign enabled (gain from -12 to 0 dB)
(S)
1 0.25
2 0.5
1 2 3 4
on
(S)
2 0.5
4
1
1 2 3 4
on
Ex : 10 dB :
Ex : 3,25 s :
Ex : 6,5 s :
19
Next
(dB)
4 1
5 2
1 2 3 4
on
(S)
1 0.25
2 0.5
1 2 3 4
on
(S)
2 0.5
4 1
1 2 3 4
on
ENGLISH