EUROM LB 2.5 Manuel D'instructions page 26

3. Fill the tank with clean, fresh, soft water (low lime or lime-free) according to the
instructions.
Weekly maintenance
Repeat steps 1 to 3 as set out above
4. Pour a cup (200ml) of white vinegar into the water-filled container in the
mechanical casing (the bit that is left when the tank is removed) and in the
water-filled tank. Leave to soak for 15 minutes. Remove the vinegar solution and
the dirt and then dry with a clean, dry cloth.
5. The lid with the moisture extractor should also be cleaned using a vinegar
solution.
6. Clean the exterior of the device with a soft, dry or slightly damp cloth.
Maintenance warnings
Make sure that the mechanical housing is never submerged in water

Do not use solvents or aggressive cleaning products when cleaning

Clean internal parts with a soft cloth; hard materials could damage the device!

Never let water sit in the water tank or casing for longer than a few days. Change

it/throw it away; rinse the tank and let the humidifier dry if you are not planning
to use it for a while.
Storing the humidifier
Clean the air humidifier as set out above. Allow to dry thoroughly.

Store in original packaging if you have it.

Place it straight up in a cool, dry place. Prevent excess heat!

Troubleshooting
If your air humidifier is not working properly, check for the following issues:
Problem
The device does not
work
The lamp is on but
steam is not emitted
Possible cause
 Control button at OFF
 No electricity
 No water in the tank
 Control button at minimal
 Moisture-outlet not
properly placed
 Too much water in the
tank
Solution
 Switch on
 plug in socket?
 is the fuse/earth leakage
circuit breaker engaged?
 no power?
 Fill the tank
 Turn to MAX
 Place moisture-outlet properly
 Pour some water from the
tank
26