Compatibility; Installation - elysia nvelope 500 Mode D'emploi

Compatibility

The nvelope 500 module requires installation into an API 500
series compatible rack frame (not included). It needs the pow-
er supply and the audio connectors provided by this frame,
and cannot be used for its intended purpose by itself.
The current consumption is 200 milliamperes (100 mA per
slot) at +/- 16 volts DC. This is actually more than some other
500 series modules consume as a result of the discrete class-A
design of the nvelope 500's audio path.
Most API 500 compatible racks meet this requirement with-
out problems, but there might be a limit on how many units
can be installed in a single rack. In case of doubt, please check
with the manufacturer of your specific rack.

Installation

Just follow these easy steps to install the nvelope 500 module:
1. Switch your API 500 series compatible rack off and discon-
nect the power cable from mains.
2. Insert the module into two free slots of your rack. Make sure
both PCB connectors match with the rack connectors.
3. Gently push the module in place – do not use any excessive
force!
4. Tighten the front panel with four screws provided by your
rack manufacturer.
5. Connect your XLR audio cables (see page 6 for more info)
and power up your rack.
That should do it. Have lots of fun with your nvelope 500!
3