Opening The Safe For The First Time - Winchester 2012 Manuel Du Propriétaire

6

Opening the safe for the first time

Must complete steps in section 4 and 5 before proceeding.
Step 1
Gently, turn handle counter-clockwise until it stops.
(About ½ inch, in some instances handle may not need to be turned)
Step 2
After entering in the factory
code, a double beep will be
Enter Factory Code : heard. Then grasp the handle
(as shown) and gently rotate
1 – 2 – 3 – 4 – 5 – 6
clockwise within 4 seconds.
Attention!
Note !!
A beep will be heard after each number is
Incorrect
Handle should move
Correct
pressed. A double beep will confirm the
to this position to
(Temporary handle could break)
correct code entry.
open safe door.