Silverline 123456 Traduction Des Instructions Originales page 6

GB
Charging
If the torch is not used on a regular basis, recharge after each use.
• Ensure the torch Switch (7) is OFF
• Mains Charger (8): Charge an empty battery for a minimum of 10 hours
• 12V Charger (9): Charge an empty battery for a minimum of 8-10 hours
Maintenance
Changing the bulb
1. Ensure the torch is not connected to either Charger (8 & 9)
2. Unscrew the Lens Ring (2)
3. Remove the lens unit and hold in one hand
4. With the other hand, squeeze together the two legs of the small spring clip
Note: Pay attention to how it is fitted
5. Carefully lift the bulb out of the lens unit
6. Pull back the rubber sleeve, half way down the white wire, and disconnect the plug
7. Taking care not to touch the glass (hold with clean tissue) re-fit the new bulb by following this
process in reverse
Cleaning
• Use a slightly damp cloth with a mild detergent to clean the torch
• Do not store in direct sunlight
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
6