Clearing Foil Jams; Cleaning And Servicing - Go A 2024 Mode D'emploi

7. When you have finished your laminating tasks, press the On/Off button
on the operating panel to switch the device off. Switch off the power
switch on the rear side of the device. Also disconnect the power plug,
particularly when the device will remain out of operation for a longer pe-
riod.

Clearing Foil Jams

The laminator is provided with a reversing function in order to clear foil jams
quickly.
1. If the foil jams, press the Reverse button
2. The jammed foil is released and is fed out at the laminator infeed slot.
3. It will probably be necessary to then clean the unit several times as de-
scribed in the Section "Cleaning and Servicing".
4. If foil jams occur repeatedly or jammed foil cannot be removed from the
laminator, please contact the sales outlet where you purchased the de-
vice (refer to Guarantee).

Cleaning and Servicing

Deposits and residual adhesive on the transport rollers can influence the re-
sults of the laminating process. Therefore, the transport rollers must be
cleaned regularly after use:
To do this, insert a folded piece of paper in the infeed slot. Residual adhe-
sive is removed and taken up by the paper when ejected. Repeat the pro-
cess several times.
Disconnect the power plug before starting to clean the unit with a damp
cloth. If necessary, the housing can be cleaned using a cloth moistened with
clean water with a little mild soap applied. Never use any solvents or aggres-
sive cleaning agents.
.
21