Axis F44 Guide D'installation page 11

How to reset to factory default settings
Important
Reset to factory default should be used with caution. A reset to
factory default will reset all settings, including the IP address,
to the factory default values.
Note
The installation and management software tools are available
from the support pages on www.axis.com/techsup
For products with multiple IP addresses channel 1 will have the
address 192.168.0.90
192.168.0.91
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See
Hardware overview on page 6.
3. Keep the control button pressed for 15–30 seconds until the
status LED indicator flashes amber.
4. Release the control button. The process is complete when the
status LED indicator turns green. The product has been reset to
the factory default settings. If no DHCP server is available on
the network, the default IP address is
5. Using the installation and management software tools, assign
an IP address, set the password, and access the video stream.
Note
To reset a single channel to the original factory default settings,
use the button provided in that product's webpage.
It is also possible to reset parameters to factory default via the web
interface. Go to Setup > System Options > Maintenance and click
Default.
AXIS F44 Dual Audio Input
, channel 2 will have the address
and so on.
11
192.168.0.90