Operation Note; Common Problem Analysis Solution - Retekess TD165 Mode D'emploi

(2)Setting of Pager ID
Touch the "learn" key, the pager LED flashing and press a number among 1 to
999, then press "ENTER" on the keypad transmitter, It's done when the number
is shown on the pager's screen. The number could be changed in the same way.
(3)Working test:
After pairing pager, press the number that you want to call and the pager will
vibrate, flash or beep, then you can press the "STOP" button to stop the notice.
(4)Battery charging
Please keep the pagers on the charging base when they are not in use.
When the pager beeps and blue LED flashes once a second, it needs be charged.
When the pager is in charging mode, the blue LED flashes once a second.
When the pager fully charged , the blue LED light on
If you want to find the pager but they are in charging, please call the number and
you can see the pager LED light flashes in red color.
(5)Delete programmed ID:
Long press the "LEARN" button and red LED flashes at the same, it's done
when you hear a beep from the pager.

Operation Note

1.Each charging base can charge up to 10 pagers
2. One keypad transmitter can pair up to 999 pagers, but one pager just can
work with only one keypad transmitter

Common problem analysis solution

Put on the charging
base but the LED
screen does not display
Receiving distance is
greatly shortened
The pager can not
receive signal from
keypad transmitter
The power adapter is
failed
The pager battery is low
The pager has not been
paired with the keypad
Out of range
3
Replace the power
adapter
Charge the pager in
time
Pair the pager with
keypad Try it in a short
distance