Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To remove old paint and varnish:
1. Use a coarse, open coat abrasive to avoid the usual clogging of the
abrasive surfaces.
2. Keep the machine moving over new areas to avoid heating and softening
the material being removed.
Try to work the entire surface at the same time by working in wide, over-
lapping arcs. Do not concentrate on small areas. When using liquid removers
or heaters to speed the work, scrape away all excess paint or varnish with
a putty knife or other suitable scraping tool, and allow the wood to be cool
and dry before sanding.
DOORS AND MOLDINGS
The "in-line" motion of the Profile Sander is ideally suited for use in the
recessed corners and on the intricate profiles found on moldings and raised-
panel doors. The diamond shaped pads make sanding the recessed corners
easy, while the wide variety of available sanding profiles allow you to exactly
match each detail of intricate molding configurations.
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers or call the Porter-Cable help line at 1-888-848-5175.
TROUBLESHOOTING
16
Publicité
Table des Matières
