Drill Press Assembly - Fox F12-943A Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING: FOR YOUR OWN SAFETY, NEVER CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETED.
TOOLS NEEDED:
ASSEMBLY OF COLUMN AND TABLE HARDWARE
1.
Position the base on the floor. Remove the
protective cover.
2.
Remove the protective sleeve from the column
tube. Place the column assembly on the base,
and align the holes in the column support with the
holes in the base.
3.
Locate four D 10mm x 40 mm long bolts (see
illustration) in loose parts bag.
4.
Install a bolt in each hole through the column
support and the base and tighten with the
adjustable wrench.
5.
Locate table crank and support lock in loose parts
box.
6.
Install support lock from left side into the table
support and tighten by hand.
7.
Install table crank assembly and tighten set screw
with a 3mm hex "L" wrench. Do not overtighten.
Set screw should be tightened against the flat
section of the shaft.
NOTE: To minimize crank backlash, tighten the
support lock, rotate the elevation worm shaft
clockwise, then assemble crank tight against table
support and tighten set screw.
8.
Check column collar for proper adjustment. Collar
should not be angled on the column and it should
be positioned so that the rack can slide freely in
the collar when the table is rotated 360° around
column table. If re-adjusted, only tighten set screw
enough to keep collar in place.
NOTE: To avoid column or collar damage, do not
overtighten set screw.

DRILL PRESS ASSEMBLY

Medium screwdriver
Combination
square
Adjustable wrench
Column
support
Column
Support
lock
Table support
Column collar
Rack
Column
D 10mm x 40 mm
long bolt
Base
Table support
Elevation
worm shaft
Table crank
Handle
29

Publicité

Chapitres

Table des Matières
loading

Table des Matières