Hilti SIW 9-A22 Notice D'utilisation Originale page 17

The belt hook allows the power tool to be attached to a belt worn by
the operator. The belt hook can be fitted to allow attachment on the left
or right side of the body.
1. Remove the battery. → page 10
2. Insert the belt hook into the opening provided at the base of the product.
3. Secure the belt hook with the two screws.
5.7 Hilti Installing the retaining strap (optional)
ATTENTION
Damage to the product and / or the retaining leash. Incorrect handling
can result in damage to the product and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use a retaining
leash with a length of more than 2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to
use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regula-
tions for working at heights.
1. Remove the battery. → page 10
2. Insert the two tabs on the retaining strap into the slots on each side of
the base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 9
6 Operation
CAUTION
Burn hazard due to hot discharged air! Heat generated during operation
is discharged through air vents and can lead to minor burns or to damage
to the power tool.
▶ Wear personal protective equipment (e.g. protective gloves, eye protec-
tion) when you are in the immediate vicinity of the air vents while the
power tool is in operation.
▶ Keep all air vents clear at all times while the power tool is in operation.
This will prevent heat build-up in the power tool.
6.1 Setting forward or reverse rotation
In the middle position, the forward / reverse selector switch serves as a
safety lock.
*2113609*
2113609
5
6
English 11