Hilti SIW 9-A22 Notice D'utilisation Originale page 14

3.2 Intended use
The product described is a hand-held cordless impact wrench. It is designed
for tightening and releasing nuts, bolts and anchors and for driving wood
screws. Accessory tools (e.g. sockets) are attached by way of a square
drive with through hole.
The impact wrench may be used only for applications that require no precise
/ specified torque. Failure to observe this point presents a risk of over-
tightening and damage to the bolt, screw or workpiece.
• Use only Hilti lithium­ion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More
information is available from your Hilti Store or from www.hilti.group
3.3 Items supplied
Impact wrench, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
3.4 Li­ion battery display
The Li-ion battery state of charge and malfunctions of the power tool are
indicated by the display on the Li­ion battery. The Li­ion battery state of
charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is
ready for use.
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch. If
the battery display LEDs blink, please observe the instructions given in
the Troubleshooting section.
8 English
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated.
The power tool is overloaded or has
overheated.
2113609
*2113609*