Use Of The Valve Adapter - Procycle 10031208 Mode D'emploi

4.2 | Use of the valve adapter

Before using the valve adapter: Gently screw the CO
end of the valve adapter until you feel resistance. Then quickly screw the
cartridge to the end of the thread, not too hard, but firmly enough to penetrate
and seal off the seal.
Now screw the flexible tyre valve access hose onto the valve adapter and the
device is ready for use.
Screwing the CO
of gas. To supply gas, unscrew the cartridge a little by turning it to the left. No
more than half a turn.
In order to stop the supply of gas to the tyre, tighten the cartridge by turning it to
the right. Only fill the tyre to the desired tyre pressure.
When using the valve adapter, always hold the cartridge upright. This way you
ensure that the cartridge gives off the maximum quantity of CO
the cartridge with bare hands as it becomes extremely cold when emptied. It is
imperative that you use gloves or only touch the valve adapter.
16
cartridge on and off on the valve adapter regulates the supply
2
Insert the repair string into the puncture
using the repair tool, allowing it to still
protrude at least 13 millimetres.
Pull out the repair tool and make sure
that the repair string remains in the
puncture.
Use further repair strings for a
larger hole as necessary.
The repair string can be shortened to
around 6 millimetres (measured from
the outer surface of the tyre).
Fill the tyre to the tyre pressure
recommended by the manufacturer and
check whether the puncture remains
air tight. To do so, check with water
whether air bubbles are expelled from
the repaired area.
cartridge onto the bottom
2
. Do not touch
2