GEV LCI 803 Mode D'emploi page 7

Setting
Perform the individual settings at the same time of
day as the time when you wish the lighting to come
on (e.g. at twilight). Turn the controller anti-clockwise
(Fig. C) to the minimum position. Then turn the
controller in the opposite direction until the LED
(Fig. C1) lights up. The set lux value now
corresponds to the ambient brightness level.
Technical information
Mains connection
Twilight switch
Switching capacity
Power consumption
Protection type
Protection class
Permissible ambient
temperature
Approx. measurements
μ = contact gap < 1.2 mm
230 V ~
approx. 5 - 300 lux, infinitely variable
max. 1000 W incandescent lamps, halogen lamps
max. 200 VA fluorescent lamps, LEDs
approx. 0.8 W
IP 44 sensor, IP 20 power section
II
approx. -20 °C ... +50 °C
Sensor Ø 14 mm,
Power section W 78 x H 39 x D 24 mm
7
Make sure that the connected lighting only
switches on after a time lag of approx. 60 seconds
after the LED comes on.
Recycling instructions
This device may not be disposed of with
unsorted household waste. Owners of old
devices are required by law to dispose of
this device correctly. Contact your local town
council for further information.
Technical and design features may
be subject to change.