INSTALLER SETTINGS
PIN CODE LOCKING
• Overview
Your heating device is protected by a safety code against non-autorized used. The PIN code (Personal Identity
Number) is a customisable 4 numbers code. When is enabled, it prevents access to the following settings:
- Selecting the Comfort mode (See installation and user manual): when the heating device is locked by PIN
code, you can access to Auto, Eco, Frost protection modes, and to put the device in standby mode.
Mode sequence under PIN code enabled: Auto Eco Frost protection
- Programming mode (See installation and user manual).
- Modifications, restrictions of temperature settings (page 3).
- Setting the Eco mode temperature lowering-level (page 4).
- Setting the Frost protection temperature (page 4).
- Temperature adjustment (page 8).
You can customized the code and modify it. Don't disclose it and keep it in a safe place, away from your device.
• Code PIN initialisation
By default, the PIN code is not enabled. The setting access is available in standby mode only.
1- Select standby mode by
pressing the key
beep
P
R
O
G
3
3
1
2
3
4
5
6
4- For others numbers, select 0 by
press
.
When 0000 appears, press again
on
to save and exit.
The PIN code is initialized, the next setting automaticaly appears: PIN Code activation.
08
2- Simultaneously press the
.
and
P
R
O
G
3
3
7
3
for at least 20 seconds.
3
3
1
2
3
4
5
6
7
20 sec.
3
3
1
2
3
4
5
6
7
3- By default registered CODE PIN
is 0000.
Press
or
to select 0.
It is blinking, save and press
to exit.
3
3
3
1
2
3
4
5
6
2
7
1