Autoadapt BraunAbility A Série Manuel D'installation page 36

36
A-Series, under vehicle Wheelchair lifts
When electric supply is connected a complete test run of the lift' s full movement cycle
must be performed. The lift will stop automatically once it has reached its set limits.
Adjusting the upper limit
1
The inner platform (bridge plate) should be level with the floor. If necessary, adjust
the upper limit as illustrated below.
The lift stops when the notch on the
clamp ring reaches the microswitch.
Level with the floor
Undo slightly
Undo slightly
Lift stops too high
Tap the clamp ring lightly to move it
closer to the microswitch. The closer
the clamp ring is to the microswitch, the
lower the lift will stop. Tighten the screws
to fix the new position.
Lift stops too low
Tap the clamp ring lightly to move it
further away from the microswitch.
The further the clamp ring is from
the microswitch, the higher the lift will
stop. Tighten the screws to fix the new
position.