Autoadapt BraunAbility A Série Manuel D'installation page 32

32
A-Series, under vehicle Wheelchair lifts
Routing hose and cables
1
Hydraulic hoses and electrical couplings between the power pack and the cassette,
can be routed through the same hole. Use existing holes and spaces in the vehicle
chassis for this purpose if possible. If this is not possible, drill a hole in a suitable
position with a 50 mm hole saw. Place the plastic grommet into the hole to protect
the Cables against sharp edges.
2
Lay the oil hose from the pump module to the cassette in an appropriate manner.
Note that bends in the hose must not be less than 30 mm in diameter in order to
ensure correct function. Connect the hose to the quick-coupling on the cassette.
The connection point on the lift
must not be twisted in any direction
to minimise the risk of leakage.
RADIUS
Min 30 mm
50 mm