Installing The Energizer (En) - Datamars 0.5 J MkII Unigizer Mode D'emploi

Installation
Read all of the safety instructions in this manual
carefully before installing the energizer.
Selecting a site for the installation
Follow these guidelines when selecting a site
for your installation.
Select a site where:
a good earth can be obtained
•
• children and animals cannot interfere with
the installation
the installation can be accessed easily
•
Make sure the energizer is installed:
• adjacent to the electric fence
• preferably in the middle of the electric
fence system
close to a mains/line power outlet (if using
•
a mains/line supply to power the
energizer)
at least 1 m (3') away from and not
•
directly above the battery (if using a
battery to power the energizer)
If your installation is outside, also make sure
that it is:
• on firm ground away from flooding
inside a protective fence, if required.
•
Installing the energizer inside
The energizer must be installed inside when
being powered by the mains/line power supply.
WARNING!
- Do not use a mains/line power extension
lead.
- Allow 25 mm (1") of clear space around
the power adaptor.
To install the energizer inside:
1 Select a suitable installation site. See
Selecting a site for the installation
69.
2 Mount the energizer on a wall. Use the
template printed on the back cover of this
manual, if required.
3 Connect the Fence earth terminal (green)
to the earthing system.
4 Connect the Fence output terminal (red) to
the fence.
5 Connect the energizer to the mains/line
power using the mains/line power
adaptor.
Note:
If the energizer is being installed inside,
it may be powered by a battery, as an
alternative to the mains/line power supply.
on page
69