Led Screen Functioning - Be Cool apollo plus Mode D'emploi

WARNING! The straps should never be twisted. The
harness buckle must be fastened correctly and the
straps should fit the child snugly.

LED SCREEN FUNCTIONING

he LED screen indicates whether the child restraint
system has been installed correctly, helping you to
follow the correct steps to install the seat as well as
guiding you if any of the control settings are wrong.
1f. The screen checks the following points:
Seat rotation
The seat has 2 functioning positions, forward facing
or rear facing, and 2 loading positions (passenger side
or driver side).
The loading positions are not suitable for use while
travelling, therefore the screen will indicate that the
position is incorrect by displaying an "X".
ISOFIX connectors
The seat is fitted with 2 ISOFIX connectors. The
screen will indicate whether the connectors are
correctly secured (see the important note in the seat
installation section).
Support leg indicator
This symbol confirms that the leg position is correct
and that it is in contact with the floor.
If all the indicators display a"
will be displayed to confirm that the seat has been
installed correctly.
Changing the batteries
To change the batteries for the installation system
there is a compartment (13) on the underneath of
the seat base.
The system uses 2 x LR6 AA 1.5v batteries. Change
the batteries whenever the low battery warning
" then the word OK
EN
31