Be Cool apollo plus Mode D'emploi page 28

EN
1. INSTALLING THE CHILD SEAT
To install the APOLLO PLUS child restraint system
follow the steps below:
1a. Unfold the leg (14) until it is in the vertical position
as shown.
1b. Move the button (11) to slide the ISOFIX (9)
backwards unfolding the connector fully. Do this for
both connectors.
Guide the connectors towards the ISOFIX anchors
1c.
in your vehicle until they lock together by clicking into
place and the indicator changes from red to green on
both sides of the base.
1d. Move the seat backwards pressing the backrest
against the vehicle seat. Then pull the safety seat
towards you to check that it is securely locked in
place.
28
1e. Press the button (15) to adjust the height of the
support leg (14) until it is firmly in contact with the
floor. It should not be on top of any type of compart-
ment. At this point make sure that the support leg is
at 90º to the safety seat.
1f. The screen (12) visually and audibly indicates if
the seat is being installed correctly. When you have
finished check that the word OK is displayed on the
screen.
The visual ISOFIX indicators show whether the con-
nector is open or closed. It may be that the connector
is closed but not locked into the ISOFIX anchor. Please
check that all the connectors are correctly locked into
the vehicle anchor points by pulling the seat once it
is installed.
To detach the seat follow the same steps in reverse: