Before First Use - Inventum GK010 Mode D'emploi

3
before the first use
Before using the appliance for the first time, you should proceed as follows: carefully unpack the appliance and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags, polystyrene and cardboard) out of the
reach of children. After unpacking the appliance, check it for external damage that may have occurred during transport.
Place the appliance on a sturdy, flat surface and make sure there is enough space all around for sufficient ventilation. A
minimum space of 10 cm is required between the appliance and the surrounding walls. In this way the appliance is able
to release heat properly, cool well and function in an energy efficient way. You can use the adjustable feet to level the
appliance. Do not place the appliance near heat sources such as central heating or a stove. Do take note of the climate class
of the appliance. When placed in a room that is too cold, the refrigerator will not function properly.
After placing the appliance, leave it for at least 3 hours before inserting the plug in the socket.
First clean the interior of the appliance. Use warm soapy water with, for instance, washing-up liquid, all-purpose cleaner or
soda. Wipe the inside of the appliance after cleaning with clean water and properly wipe everything dry. Leave the appliance
to dry for 1 to 2 hours.
ALIGNING THE DOORS
When the doors of the appliance have been aligned correctly in relation to the top side of the appliance, it is possible to
adjust the height. If necessary, take the following steps:
Important: the maximum height adjustment is 5 mm.
Loosen the lock nut by two clockwise turns using an open-end wrench. Now it is possible to turn the adjusting nut in order
to move the door up or down. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
adjusting nut
fixed shaft
not level
right
leveling feet wrench
lock nut
When the door is too low:
Open the door, use an open-end wrench to loosen the lock nut and turn the adjusting nut anti-clockwise to move the door
upwards. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
When the door is too high:
Open the door, use an open-end wrench to loosen the lock nut and turn the adjusting nut clockwise to move the door
downwards. When the door is in the correct position, tighten the lock nut again, anti-clockwise.
29
English •