Before First Use; Door Height Adjustment - Inventum CA010 Mode D'emploi

3
before the first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material and promotional stickers. Keep the material (plastic, polystyrene and cardboard) out of reach of children. Check
the appliance after unpacking for any damage, possible from transportation. Place the appliance on a flat and stable surface.
Make sure there is enough open space around the appliance for the intake and/or outlet vents. A minimum clearance of 10 cm
is required between the appliance and any adjacent walls. The appliance needs good ventilation for easy dissipation of heat,
high efficiency of refrigeration and low power consumption. Note: check the climat class of the appliance. When installing the
appliance in a environment that is not suitable, the appliance can not function properly.
Leave the appliance to stand for at least 3 hours before you insert the plug into the socket.
First clean the interior of the appliance. Use warm water and a neutral detergent. After cleaning, rinse the interior with clean water
and rub dry. Leave the appliance to dry for 1 to 2 hours.

DOOR HEIGHT ADJUSTMENT

If the doors of the appliance are not aligned, the height of them can be adjusted. If required, please follow the following steps:
Important: the maximum height adjustment is 5 mm.
Rotate the locking nut clockwise with a wrench for two full rotations to loosen it. You can now rotate the adjusting nut to raise or
lower the height of the door. Once the door is set to your desired position, then tighten the locking nut by rotating it anti-clockwise.
adjusting nut
fixed shaft
not level
right
leveling feet wrench
locking nut
When the fridge door is too low:
Open the door, use a wrench to rotate the adjusting nut anti-clockwise to raise the height of the door. Once the doors are aligned,
tighten the locking nut by rotating it anti-clockwise.
When the fridge door is too high:
Open the door, use a wrench to rotate the adjusting nut clockwise to lower the height of the door. Once the doors are aligned,
tighten the locking nut by rotating it anti-clockwise.
20
• English