SOUNDMASTER SCD8100 Mode D'emploi page 20

main unit will switch to standby mode as no or less audio signal input. This is not a malfunction!
In on mode, press repeatedly the "EQ" button to select a sound effect:
FLAT, ROCK, POP, JAZZ, CLASSIC
This unit can switch to standby automatically after a defined period.
Set the sleep timer
1. When the unit is turned on, press the "MENU" button, select the point "SYSTEM" with the
" " or " " button and press "ENTER /
2. Select the point "SLEEP" and press "ENTER /
3. Select with the "
and press "ENTER /
Note: When the sleep timer is activated, the upper-right side of the display shows the sleep time
counter.
Deactivate the sleep timer
1. Repeat the steps 1 and 2 to enter the sleep timer menu.
2. Select with the "
When the sleep timer is deactivated, the sleep time counter disappears.
You can setup Alarm 1 and Alarm 2.
1. When the unit is turned on, press the "MENU" button, select the point "SYSTEM" with the
" " or " " button and press "ENTER /
2. Select the point "Alarm" and "ENTER /
3. Select "Alarm 1 Setup" or "Alarm 2 Setup" and press "ENTER /
4. Set the alarm time and press the "ENTER /
5. Set the duration time (15, 30, 45, 60, 90 minutes) with "
"ENTER / " button.
6. Select the wake up source (DAB, FM, CD, USB, CARD or buzzer) and press again the
"ENTER / " button.
7. Select the wake up frequency (Daily, Once, Weekends, Weekdays) and confirm the
selection with "ENTER /
NOTE: If you have select "Once", set the date for wake up and press "ENTER /
8. Now adjust the volume level with the "
9. If you want to activate the alarm, set "Alarm on". If you want to deactivate the alarm, set
"Alarm off". When the alarm is activated, the alarm icon is shown in the display.
Deactivate sounding alarm tone
When the alarm sounds, press the " / SOURCE" button to deactivate the sounding alarm tone.
Snooze
EQUALIZER
SLEEP TIMER
" or " " button the desired sleep timer period (Off, 15, 30, 45, 60, 90)
" to confirm.
" or " " button the setting "Off" and press "ENTER /
ALARM
".
SCD8100 / English Instruction Manual
" to confirm.
".
" to confirm.
" to confirm.
" button again.
" or "
" or " " button and press "ENTER /
8
" to confirm.
" to confirm.
" and confirm with the
".
".