White&Brown CP 440 Mode D'emploi page 10

All manuals and user guides at all-guides.com
notice CP 440/460 15/06/05
• Set the appliance on a flat level surface.
• Plug the power cord onto the cord receptacle. Plug into the
mains. The red light indicator is on. It stays on as long as the
appliance is plugged.
• Preheat for 8 minutes.
• Once the green indicator lights on, the warming tray is ready
to be used.
• According to what you want to do, you can let the appliance
plugged : it works continuously, and the green light goes on
and off as the unit maintains the correct temperature. You
can also disconnect the appliance to set directly the
warming tray on the table. It will continue to give off heat for
approximately 60 minutes.
Pay attention :
This appliance is intended to keep warm any kind of warm
resistant plate, dish or casserole. Anyway, some kind of
material may scratch the stainless steel surface of the warm
tray (such as porcelain...). Take care not to scratch dishes on
the warm tray surface.
Helpful hints :
To keep warm as long as possible, it is better to use covered
dished with a flat base and not too high edges.
CLEANING
CLEANING
• Unplug and let the appliance cool completely before
cleaning.
• Wipe the warm tray with a damp cloth.
• Dry thoroughly.
• Do not clean any part of the unit with abrasive cleaners e.g.
souring powders, scouring pads, wire wool, washing soda
or bleach.
• Do not immerse any part of the appliance.
• Do not immerse the power cord.
11:30 Page 10
USE
USE
10