Matco Tools MT1811 Instructions De Fonctionnement page 3

air supply
Tools of this class operate on a wide range of air pressures. It is
recommended that air pressure of these tools measures 90 PSI at the tool
while running free. Higher pressure and unclean air will shorten tool life
because of faster wear and may create a hazardous condition.
Water in the air line will cause damage to the tool. Drain the air tank daily. Clean
the air inlet filter screen on at least a weekly schedule. The recommended
hook-up procedure can be viewed in Figure 1.
The air inlet used for connecting air supply has standard 1/4" NPT
American Thread .
Line pressure should be increased to compensate for unusually long air hoses
(over 25 feet) . Minimum hose diameter should be 3/8" I .D . and fittings should
have the same inside dimensions .
WarranTy
Matco warrants its air tools for a period of 1 year to the consumer. We will
repair any MT Series air tool covered under this warranty which proves to be
defective in material or workmanship during the warranty period. In order
to have your tool repaired, return the tool to either of the Matco Authorized
Warranty Centers listed to the right, freight prepaid. Please include a copy of
your proof of purchase and a brief description of the problem. The tool will
be inspected and if any part or parts are found to be defective in material or
workmanship, the tool will be repaired free of charge and returned to you
freight prepaid .
This warranty gives you specific rights. You may also have other rights which
vary from state to state.
The foregoing obligation is Matco's sole liability under this or any implied
warranty and under no circumstances shall Matco be liable for any incidental
or consequential damages .
Note: Some states do not allow the exclusion or limitation of
incidental or consequential damages so the above limitation or exclusion may
not apply to you.
MT1811
MT1811 Short Barrel Air Hammer
feaTures
• Integrated chuck on barrel .
• Variable speed trigger for control.
• Metal valve assembly for increased durability.
• Lighter fluted barrel for easier use .
• Rubber bumper vibration dampening for comfortable use over extended periods of time.
• Center handle design for superior balance during use .
• Comfort, power, and durability at its best.
Nipple
TrouBleshooTing
Other factors outside the tool may cause loss of power or erratic action.
Reduced compressor output, excessive drain on the air line, moisture or
restrictions in air pipes or the use of hose connections of improper size or poor
conditions may reduce air supply. If outside conditions are in order, and the
tool still performs erratically, disconnect tool from hose and take tool to your
nearest Matco authorized service center .
luBricaTion & MainTenance
Lubricate the tool daily with a good grade of air tool oil. If no air line oiler is
used, run 1/2 oz . of oil through the tool . The oil can be squirted into the tool air
inlet or into the hose at the nearest connection to the air supply, then run the
tool . A rust inhibitive oil is acceptable for air tools .
figure 1
MATCO AIR COMMANd
Tool Repair SV
1330 Commerce Dr .
Stow, OH 44224
(800) 433-7098
dISCOuNT TOOL REPAIR
3433 Losee Rd . #1
North Las Vegas, NV 89030
(702) 657-6570
3
PNEuTOOL PARTS &
SERVICES CO., LTd
33 Haas Road
Toronto, ON M9W 3A1 Canada
(416) 748-1200
(888) 748-1201 (Toll-Free in
Canada)
dIVERSIFIEd POWER
INC.
90 Buttermill Avenue,
Vaughan, Ontario
L4K 3X7 Canada
Tel: 905-760-9077
Toll Free: 800-821-7975
04/30/12