Connections; Operation; Selecting A Sound; Saving A Favorite Sound - VOX Amplification Giulietta VGA-3D Manuel D'utilisation

TIP The auto power-off enable/disable setting is
remembered even when the power is off.
TIP Auto power-off is enabled when the instru-
ment is shipped from the factory.

Connections

1. Make sure that batteries are installed.
2. Connect the guitar output jack of this instru-
ment to a guitar amp or other PA equipment.
When doing so, make sure that the volume
is down on any devices that you are con-
necting to.
If you're using headphones, connect your head-
phones to the guitar's headphones jack.
3. Set the guitar's volume knob to the minimum
level.
4. Press the power button to turn the power on.
5. Adjust the volume by gradually raising the
volume of the guitar amp and the volume
knob of the guitar.
6. To turn the power off, set the VOLUME knob
to the lowest level, and hold down the power
button.

Operation

Selecting a sound

1. Use the Group selector to select a Group.
The Groups are organized by guitar type,
such as electric or acoustic. Select the basic
Group of sound you want (See page 13
"Table of Groups and sounds").
2. Use the three-way switch to select a sound.
Here you can select one of the three varia-
tions that are in each Group.
3. Use the FX/CANCEL button to turn the effect
on/off. Use the DRIVE/REVERB knob to
adjust the depth of the effect.
4. Use the volume knob to adjust the volume.

Saving a favorite sound

If you save a favorite sound, you'll be able to recall
it at any time. (See "7. WRITE button and LED.")
1. Make the settings that you want to save as
a favorite sound, and then press the WRITE
button.
The WRITE LED blinks red if a user program
is selected, or blinks green if any other
program is selected.
2. Use the Group selector and the three-way
switch to select the save-destination user
program (PROGRAM 1–3 or 4–6).
3. Press the WRITE button once again to save
the settings (see "7. WRITE button and
LED"). The WRITE LED is lit green.
TIP To cancel without saving, press the FX/
CANCEL button without specifying a
save-destination while the WRITE LED is
blinking (ready to write).

Restoring the factory settings

The six programs in the user banks U1 (User 1),
U2 (User 2), the start-up effect on/off setting, the
battery type selection, and the auto power-off
enable/disable setting will be initialized to their
factory-set condition when you execute the
following operation.
1. Make sure that the power is off.
2. While holding down the FX/CANCEL button
and the WRITE button, press the power but-
ton to turn the power on. When the WRITE
LED starts blinking red, release the buttons
you were pressing.
TIP If you decide to cancel without initializing,
press the FX/CANCEL button at this time.
3. Press the WRITE button; the WRITE LED
changes from blinking to lit, and initialization
begins. When initialization is completed,
the WRITE LED lights green, and then the
instrument starts up normally.
Never turn off the power while initialization
is in progress.
When this operation is completed, all programs
and settings that you had saved are erased and
returned to their factory-set condition.
11