Inserting/Exchanging Gobos - Futurelight PCS-1200 MK-2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The lamp life given by the manufacturer must never be exceeded. This is why you need to take notes on the
operational time of the lamp or check the operating hour meter regularly and replace the lamp in time.
Keep exchanged lamp in a protective container and remove accordingly.
During the operation, the lamp reaches temperatures of up to 600° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the housing screws and remove the housing cover.
Step 2: Loosen the knurled-head screws on both ends of the lamp.
Step 3: If replacing the lamp, remove the old lamp from the lamp holder.
Step 4: Insert the lamp into the lamp holder.
Step 5: Tighten the two knurled-head screws.
Step 6: Replace the housing cover and tighten the housing screws.

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
Do not operate this device with opened cover!
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
33/99
51840006_V_1_2.DOC

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Psc-1200 mk-2

Table des Matières