Starting A Console Session Using Dialup; Establishing A Webui Management Session - Juniper NETSCREEN-ISG 2000 Mode D'emploi

Chapter 3 Configuring the Device

Starting a Console Session Using Dialup

Each NetScreen-ISG 2000 provides a modem port that allows you to establish a remote
console session using a dialup connection through a 9600 bps modem. Dialing into the
modem establishes a dialup console connection.
Note: The Terminal type for dialup sessions must be vt100. For example, in Hilgraeve
HyperTerminal (a commonly-used terminal application), select
Connect > Remote System > vt100 from the Term Type menu.

Establishing a WebUI Management Session

To access the NetScreen-ISG 2000 device with the WebUI management application:
1. Connect your computer (or your LAN hub) to the MGT interface using a CAT5
Ethernet cable.
2. Launch your browser, enter the IP address of the MGT interface in the URL
field, then press enter.
For example, if you assigned the MGT port an IP address of
enter the following:
http://10.100.2.183
The NetScreen WebUI software displays the login prompt.
3. Enter netscreen in both the Admin Name and Password fields, then click
Login. (Use lowercase letters only. The Admin Name and Password fields are
both case sensitive.)
The NetScreen WebUI application window appears.
34
10.100.2.183
/16,
User's Guide