Configuring The Device For Telnet And Webui Sessions; Starting A Console Session Using Telnet - Juniper NETSCREEN-ISG 2000 Mode D'emploi

The following CLI command creates an access policy that permits all kinds of outbound
traffic, from any host in your trusted LAN to any device on the untrusted network.
set policy from trust to untrust any any any permit
Use the save command to store changed information.
Important: Your network might require a more restrictive policy than the one created in
the previous example. The example is NOT a requirement for initial configuration. For
detailed information about access policies, see the NetScreen Concepts and Examples
ScreenOS Reference Guide.
Note: Once you have set the port and interface IP address, it is highly advisable to change
the admin name and password immediately. For more information, see
Admin Name and Password" on page
C
ONFIGURING THE
You can also use Telnet (or dialup) to establish console sessions with the
NetScreen-ISG 2000. You can start management sessions using the NetScreen WebUI, a
web-based GUI management application.

Starting a Console Session Using Telnet

To establish a Telnet session with the NetScreen-ISG 2000:
1. Connect an RJ-45 cable from the MGT interface to the internal switch, router, or
hub in your LAN (see
page
2. Open a Telnet session, specifying the current MGT interface IP address. For
example, in Windows, click Start > Run, enter telnet ip_addr (where ip_addr
is the IP address of the MGT interface), then click OK.
For example, if the MGT interface has an IP address of
telnet 10.100.2.183
3. At the Username prompt, type your admin name (default is netscreen).
4. At the Password prompt, type your password (default is netscreen).
Note:
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To change this timeout interval:
set console timeout number
where number is the length of idle time in minutes before session termination.
To prevent any automatic termination, specify a value of 0.
NetScreen-ISG 2000

Configuring the Device for Telnet and WebUI Sessions

D
EVICE FOR
"Setting the IP Address for the Trust Zone Interface" on
31).
Both admin name and password are case-sensitive.
30.
T
ELNET AND
"Changing Your
W UI S
EB ESSIONS
10.100.2.183
, enter:
33