Mains Connection; Operation; Setting The Operating Mode - Conrad 1302513 Mode D'emploi

11. Mains connection

The mains socket to which the LED light system is connected must be close to the device and
easily accessible to quickly separate the device from the mains voltage in case of an error.
Ensure that the voltage indication on the LED light system matches the mains voltage of your
power supply. Never try to operate the device with any other voltage.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause poten-
tially fatal electric shock.
Make sure that no cables are lying around openly. Install cables professionally to prevent acci-
dents.
Never overload the mains output (1) POWER OUTPUT. Max. 20 (at 230 V) or 10 (at 110 V) equal LED
light systems can be connected to this connection. Connect no other devices than correspond-
ing LED light systems here, since the mains connection (1) POWER OUTPUT may otherwise be
overloaded.
• Connect the mains connector of the mains cable to the mains connection (1) POWER INPUT at the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
• Through the mains connection (1) POWER OUTPUT, other LED light systems can also be connected to the mains.
For this, plug in a mains extension (available in specialist stores) into the mains connection (1) POWER OUTPUT
and connect it to the mains connection of another device.

12. Operation

a) Setting the operating mode
The LED light system can be controlled with the integrated controller or with an external DMX controller. Additionally,
it can be used as a master device with integrated controller to control other connected effect lights synchronously in
master-slave operation, or as slave device via the controller of another effect light.
The operating modes are set in the menu via the LED display (7) and the function buttons MENU (6), UP (8), DOWN
(9) and ENTER (10).
• Push the MENU (6) button repeatedly until the desired function is displayed.
• Push the ENTER button (10) to confirm your selection.
• Select the desired option with the UP (8) and DOWN (9) buttons.
• Push the ENTER button (10) to confirm your selection.
☞
To return to the main level in the menu, push the button MENU (6).
29