Registering With The Bs800 Homeguard - Ebode eSD18 Guide Utilisateur

All manuals and user guides at all-guides.com

7. Registering with the BS800 HomeGuard

1. Set the detector to the correct mode, being Remote or Sensor.
2. Access the menu of the console, a PIN will be requested.
3. Enter your PIN, factory default is [0000]: You will hear three high tones and one low tone
as confirmation. The green indicator starts flashing.
4. Press 1 on the keyboard of the HomeGuard; One high tone is given for confirmation.
5. Press the test button of the sensor; One low tone is given for confirmation.
6. Repeat step 1-3 for every Detector you wish to register.
7. Press any button on your HomeGuard keyboard to finalise the registration procedure.
One short low tone is given and the green indicator will stop flashing.
If successive commands are not entered within a period of 15 seconds, the base station
returns to normal operation. To restart the registration you must start the procedure from
step1.
Note. The RF range can be affected by a number of factors including building construction,
so make sure you test the detector in the desired location using the detector's main test
button. The detector will sound an alarm and when in range the console will also
acknowledge the detector.
7-5-2013 6 ebode eSD18