Registering With The Sc28 Home Protector - Ebode eSD18 Guide Utilisateur

All manuals and user guides at all-guides.com
Figure 1.2

6. Registering with the SC28 Home Protector

1. Set the detector to the correct mode, being Remote or Sensor.
2. Access the menu of the console, done by either using the menu UP or DOWN button.
The display now shows ENTER PIN.
3. Enter your PIN; factory default is [0000]: The display is cleared and shows a * for each
number entered.
4. When the PIN code has been entered correctly, the word INSTALL will show up on the
display.
5. Press OK.
6. Press the TEST button on the Detector. The console will beep to confirm. The display will
either read ZONE 1 SET (when sensor mode was set) or RMOT 1 SET (when remote mode
was set).
A memory space for a sensor is called a zone. If you have more than 1 sensor installed,
they will be shown e.g. ZONE 2 SET, ZONE 3 SET, ... ZONE 30 SET. You can choose in which
zone you want to install the sensor. If you want to install the sensor in zone 3, press 3 on
the number pad before executing step 5.
It's advisable to write down which zone contains which sensor for your reference.
7. Repeat step 5 for every Detector you wish to register.
8. Press CLEAR to go back to the first menu item. Press CLEAR again to quit the menu. To
confirm this choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If
you choose No, you go back to the first menu item.
7-5-2013 5 ebode eSD18