Crane EE-4109 Manuel D'instructions page 7

DO NOT operate the humidifier without water in the water tank.
DO NOT plug or unplug the cord with wet hands; electric shock
could happen, as with any electrical appliance.
ASSEMBLY
1. Lift the water tank off the central body.
2. Turn over the water tank and unscrew the water tank cap
at the bottom of the tank by turning it counterclockwise.
(See Fig. 6)
3. Fill water tank with cold water; do not fill all the way to
the rim.
(See Fig. 7)
Note: To avoid possible white dust due to hard water it
is recommended to use distilled water.
DO NOT
use hot water. Use cool tap water.
DO NOT
add any medication to other additives to the
water
DO NOT
pour water into Vapor Outlet Channel (part 7,
Fig.2 on page 4)
4. Replace the water tank cap, aligning the threads on the
tank with the threads on the cap, and turn it clockwise.
(See Fig. 8)
5. Turn the tank over, holding it by the top handle, and
place it on the central body, making sure it fits perfectly.
Place the water tank cap with output slots on top of the
water tank. (see Fig. 9)
Note: Do not attempt to move humidifier while water tank is
placed on the water basin. Doing so may cause leakage of
water. Also do not place humidifier on the floor. Place
humidifier on an elevated surface.
6. Plug the power cord into a wall socket (do not use
extension cord) and turn on the unit. The On/Off switch
is located at the turning knob, "O" = off, "I" = on.
(see Fig. 10)
6
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10