Publicité
2.
Secure the Cabinet
Pilot Hole
Trous-pilotes
Orificio guía
Lag Bolt
Tire-fond
Perno de fijación
Screw
Pilot Hole
Vis
Trous-pilotes
Tornillo
Orificio guía
WARNING: Risk of property damage. Use care when moving the cabinet to
avoid impacting, sliding, or side-loading the legs.
NOTE: The K-2607 bridge cabinet is designed to be installed with the K-2604 vanity
and is not intended to be installed individually. Read both product installation
instructions before beginning. The vanity should be installed before the bridge
cabinet.
Install Spacers – Only for Installation of the Bridge between Two Vanities
IMPORTANT! Ensure spacers do not extend past the top edge of the bridge.
Improper placement of spacers may interfere with the installation of the stone top.
Remove the protective film from the adhesive strips on one of the spacers.
Carefully position the spacer on the side of the bridge, flush with the top and
front edges.
Take a second spacer and position it on the side of the bridge, flush with the top
and back edges.
Flip the bridge over and repeat above for the other two spacers.
Position and Level
To properly secure the cabinet, 2x6 backing material must be installed behind the
finished wall. Refer to the K-2604 vanity installation instructions for site
preparation.
Use care to lift and place the cabinet in position against the previously installed
vanity and finished wall. Do not slide or side-load the legs.
Verify the cabinet is level and flush against the vanity, and the back rail is plumb
against the wall. If necessary, turn the leveler(s) to adjust the unit.
Secure
Ensure the bridge is pushed up snug against the vanity and wall.
Kohler Co.
Spacer
Espaceur
Espaciador
Siliconized Acrylic Caulk
Mastic à l'acrylique siliconée
Sellador acrílico siliconado
Leveler
Levier
Nivelador
5
1147373-2-B
Publicité
