Setting The Preset Time - Sentiotec PRONET 1-027-363 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
Instructions for installation and use

6.3. Setting the preset time

WARNING!
Risk of fire
Flammable objects that are placed on the sauna heater could ignite and
cause fires.
● NEVER place flammable objects on the sauna heater.
● Make sure that NO flammable objects have been placed on the
sauna heater before the sauna control unit is switched on.
To start the sauna control unit with time-delay or at a specific time, a preset time
must be set under the menu item Timer. The required functions must be activated
beforehand. To do so, proceed as follows:
1. Use the Sauna/Humidity menu to set the preferred settings for the sauna
and humidity.
2. Switch the function to ON.
► The sauna heater temporarily starts heating.
3. Once all settings have been made, switch to the Timer menu.
4. Now set the preferred preset time in hours and minutes under the item
Preset time (observe that this setting controls the amount of time until the
control unit switches on).
5. Press Start.
► All functions started beforehand are stopped. The preset time is now
active and the remaining time is shown in the main menu, as shown in
the following figure:
► Example:
► Once the time displayed has elapsed, the previously selected
► Clicking on this window automatically redirects you to the tim-
WORLD OF WELLNESS
Preset time: 03h 08 min
functions start.
er menu.
p. 16/20

Publicité

Table des Matières
loading

Table des Matières