Enerwatt EWC12-148 Manuel Du Propriétaire page 8

TROUBLE SHOOTING
TYPES OF
PROBLEMS
Charger does not work?
Charger has no DC output?
No Charging Current?
Full / Float light
won't come on?
MAINTENANCE
The charger is maintenance free. If the power cord is damaged, the charger must be left to the reseller for maintenance.
The case should be cleaned occasionally. The charger should be disconnected from the power while cleaning.
1 YEAR PRODUCT WARRANTY
The charger is substantially free from defects in material and workmanship under normal use for a period of 1 year
from the date of purchase.
|
Distribué par Distributed by:
Trans-Canada Energies
700, chemin du Grand Bernier Nord
Saint-Jean-sur-Richelieu
(Québec) J2W 2H1
FABRIQUÉ EN CHINE - MADE IN CHINA
INDICATION POSSIBLE CAUSES
No Indicator
No AC power
lights on.
- Output is short circuited
Fault RED LED
- Reverse polarity
is ON.
connection to Battery
- Battery is severely
Fault RED LED sulphated
is Flashing. - Battery has a damaged cell
- Overheat protection mode
- Battery capacity too large
Fault RED LED is
for the battery charge and
Flashing.
it has timed out.
- Battery is defective
Or Full LED is
- Battery is severely
Flashing.
sulphated.
MODEL: EWC12-148
SUGGESTED SOLUTION
Check AC connections and make sure Power
is switched ON.
- Check DC connection between charger and battery
and make sure they are not short circuiting.
- Check that the crocodile clips haven't fallen
off the battery.
- Check that the crocodile clips / ring terminals
are connected to the correct polarity.
- Check the Battery condition, age, etc.
- Battery may need replacement.
- Move battery & Charger to cooler environment.
- Check the charger specification matches
the battery capacity.
- Battery cannot be charged and must be replaced.
- Charge rate selected might be too low, switch
charger off and on and try a higher charge rate
setting providing it doesn't exceed the maximum
charge limit for your battery.
Phone/Téléphone: 450 348-8720
Toll free/Sans frais: 1 800-661-3330
USER'S MANUAL
8