Télécharger Imprimer la page

Power Fist 8825119 Manuel D'utilisateur page 8

Chariot élévateur hydraulique, 330 lb

Publicité

Les langues disponibles

Les langues disponibles

Maintain the product by adopting a program of conscientious repair and
maintenance in accordance with the following recommended procedures. It
is recommended that the general condition of any tool be examined before
it is used. Keep your tool in good repair. Keep handles dry, clean, and free
from oil and grease. The following chart is based on a normal operation
schedule.
Maintenance Interval
Before Use
After Use
TROUBLESHOOTING
WARNING
If the table is not performing properly, you may need to bleed the air from
the system.
Use the table below to troubleshoot problems before contacting service
personnel or your local dealer. If the problem continues after
troubleshooting, call your local dealer for assistance.
Failure
Table fails to
descend when
first used.
Control lever
does not lower
the table easily.
Table is not
performing
properly.
Maintenance Point
Inspect the general condition of the cart. Check for
loose hardware, misalignment of binding parts,
cracked or broken parts, and any other condition
that may affect its safe operation.
Occasionally check the condition of the casters.
Wipe external surfaces of the tool with clean cloth.
Possible Cause
Bottom of pull rod drops out
from the bolt during
transportation or assembly.
Hex nut may be over
tightened.
Air is entering into the oil
gradually after some period of
usage.
Corrective Action
Put it back.
Loosen the hex nut by turning
counter-clockwise, slightly
adjusting the bolt to make sure
the control lever can lower the
table, and then tighten the hex
nut.
Remove load from the table.
Release the control lever, and
then repeatedly pump the foot
pedal to raise the table to its
highest position.
Squeeze the control lever while

Publicité

loading