Revell Control Audi R8 Notice D'utilisation page 7

4 sTarT preparaTIon
Fit the antenna in the antenna socket
of the remote control and carefully
tighten (4A). To switch on the model,
set the switch (1D) on the underside of
the vehicle to ON (4B).
To switch on the remote control, move
the ON/OFF switch (2D) to ON. The ON/
OFF switch (1D) and (2D) on the model
and remote control must be set to OFF
after use. Otherwise, a drive command
can accidentally be triggered, causing the
vehicle to drive away on its own, which
can lead to considerable damage.
6 vehICle ConTrol
6A In order to drive forwards, push the throttle lever (2B) on the left side of the remo-
te control forwards.
6B In order to drive backwards, push the throttle lever (2B) back.
6C To drive along a left curve, press the right steering lever (2A) on the remote
control to the left.
6D To drive along a right curve, push the right steering lever (2A) on the remote control
to the right.
InsTruCTIons For saFe drIvIng
GEnERAL DRiVinG TiPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the lever for forwards and reverse travel immediately in
order to prevent damage to the electronics.
THE SuiTABLE DRiVinG EnViROnMEnT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
12
5 sTeerIng TrIM adjusTMenT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
if the vehicle pulls to the left or right
while driving without steering...
use the straight-ahead trimming (1C) to
correct the wheel alignment by turning it in
the opposite direction. The wheel alignment
can be found on the bottom of the vehicle
(cf. 5).
TrouBleshooTIng
Problem: The vehicle does not move.
Cause:
• The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model.
• Please replace with new batteries.
Problem: Remote control does not work.
Cause: • The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Check whether the batteries are inserted correctly.
• Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: • The batteries are depleted.
• The connection between the remote control and vehicle has been severed.
Remedy: • Insert new batteries.
• When the model is further than 10 metres away, move towards the model.
Additional tips and trick can be found online at www.revell-control.de.
servICe noTes
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13