Publicité
Les langues disponibles
Les langues disponibles
• The exercise cycle has a magnetic brake system.
• The equipment is dependent of revolutions per minute.
• Please ensure that liquids or perspiration never enter the machine or the
electronics.
• Before use, always check all screws and plug-in connections as well as
respective safety devices fit correctly.
• Always wear suitable shoes when using.
• Nobody may be in the moving range of a training person during training
Instructions for Assembly
RISK!
Ensure that your working area is free of possible sources of danger,
for example don't leave any tools lying around. Always dispose packaging
material in such a way that it may not cause any danger. There is always
a risk of suffocation if children play with plastic bags!
• Ensure that you have received all the parts required (see check list) and
that they are undamaged. Should you have any cause for complaint, please
contact your KETTLER dealer.
• Before assembling the equipment, study the drawings carefully and carry
out the operations in the order shown by the diagrams. The correct sequence
is given in capital letters.
• The equipment must be assembled with due care by an adult person. If in
doubt call upon the help of a second person, if possible technically talented.
• Please note that there is always a danger of injury when working with tools
or doing manual work. Therefore please be careful when assembling this
machine.
• The fastening material required for each assembly step is shown in the
diagram inset. Use the fastening material exactly as instructed.
• Bolt all the parts together loosely at first, and check that they have been
List of spare parts page 20-21
When ordering spare parts, always state the full article number, spare-partnumber,
the quantity required and the S/N of the product (see handling).
Example order: Art.no. HT1006-100 / spare-part no. 68009040 / 1 pieces /
S/N ....................
www.kettlersport.com
Waste Disposal
KETTLER products are recyclable. At the end of its useful life please dispose
of this article correctly and safely (local refuse sites).
assembled correctly. Tighten the locknuts by hand until resistance is felt,
then use spanner to finally tighten nuts completely against resistance (locking
device). Then check that all screw connections have been tightened firmly.
Attention: once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be replaced.
• For technical reasons, we reserve the right to carry out preliminary assembly
work (e.g. addition of tubing plugs).
• This manual can be downloaded from
www.kettlersport.com.
5
Publicité
