CREE LIGHTING ZR Serie Instructions D'installation page 4

ELECTRICAL CONNECTIONS
STEP 1:
For 120/277V applications make the following Electrical
Connections:
a. Connect the black LUMINAIRE lead to the supply lead.
b. Connect the white LUMINAIRE lead to the neutral
supply lead.
c. Connect the green or green/yellow ground lead to the
green supply lead.
For 208/240V applications, make the following Electrical
Connections:
a. Connect Hot 1 supply lead to the black lead.
b. Connect Hot 2 supply lead to the white lead
c. Connect the green or green/yellow ground lead to the
supply ground lead.
STEP 2:
Turn the ON/OFF switch on the side of the emergency driver to
ON status when installation is completed and AC power has been
supplied.
See Figure 9.
ON Switch
9
© 2020 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
registered trademarks of Cree, Inc. ZR14™, ZR22™ and ZR24™ are trademarks of Cree Lighting, A company of IDEAL
INDUSTRIES. Armstrong® is a registered trademark of AWI Licensing LLC.
4 of 4
LINE
OR HOT 1
GREEN
NEUTRAL
OR HOT 2
NOTE: DO NOT put the switch on the side of the
emergency driver to ON until installation is complete
and AC power is supplied
and the Cree logo are
®
LUMINAIRE
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
www.creelighting.com
LPN00678X0008A0_B