Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION OF SIDE BODIES AND TRIM
Before installing supply valves make sure that
the cartridge nuts are in place. The cartridge
and cartridge nuts were properly installed and
tested before leaving the factory. Although it is
unlikely, it is nevertheless possible that through
the handling of the valve by any number of
persons, the cartridge nuts may not be prop-
erly installed. This should be carefully checked
at time of installation. If the cartridge nuts are
not properly installed, water pressure could
force the cartridge out of the valve. Personal
injury or water damage to the premises could
result.
1. Thread lower mounting nut
down the supply valve body.
Place the flat support washer on
top of the mounting nut.
TOP
MOUNTING NUT
SUPPLY VALVE
MOUNTING WASHER
LOWER
MOUNTING NUT
INSTALLATION OF SPRAY ASSEMBLY
GASKET
HANDLE SCREW
HANDLE ADAPTER
DISCHARGE
TUBE (SHORT)
RUBBER WASHER
2. From under the bidet, insert valve body up
through holes. Thread top mounting nut onto
valve body with flat side of nut toward bidet.
Screw nut down until top of valve body is 3/8"
(16mm) to 7/16" (18mm) from top of deck.
(See figure 1).
3. Repeat installation with the otherside
4. Hand tighten the mounting nuts from
underneth. Do not tighten completely until after
the installation of the supply lines.
5. Install insert handle adapter onto stem ex-
tension.
Install handle screw and tighten.
Place handle skirt over insert handle adapter.
Install handle insert, making sure notch on the
insert is down and aligned with key on handle
adapter. Fit gasket into handle cap recess
and screw cap into place.
3/8" (16mm)
to 7/16" (18mm)
1. Install rubber washer over threaded nipple
HANDLE CAP
of spray nozzle assembly and place down
through smaller hole in bidet bowl. From
CONCENTRIX
below install rubber washer, metal washer
INSERT HANDLE
and mounting nut and tighten.
(NOT FURNISHED)
HANDLE SKIRT
2. Attach supply tube to spray assembly
nipple.
ESCUTCHEON
TOP MOUNTING NUT
MOUNTING WASHER
BOTTOM MOUNTING NUT
VALVE BODY
SUPPLY TUBE
FITTING
SPRAY NOZZLE
ASSEMBLY
RUBBER WASHER
MOUNTING NUT
3/8" X 3/8" X 20"
SUPPLY TUBE
TOP OF VALVE BODY
FIGURE 1
METAL WASHER
Publicité
