Setup Location Requirements; Unpacking; Disposal Of The Packaging; Electrical Connection - Caso AirVital Pro Mode D'emploi

Table des Matières

Les langues disponibles

13.3 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location

must fulfil the following prerequisites:

• The device must be set up on a firm, flat, horizontal and water-resistant surface with

sufficient load-bearing capacity for the air humidifier and content.

• Choose the setup location in such a way that children cannot reach the device.

• The device is not intended to be installed in a wall or a built-in cupboard.

• Do not set up the device in a hot, wet or extremely damp environment or near

flammable material.

• The device requires an adequate flow of air in order to operate correctly. Leave a

clearance of 15 cm on all sides.

• Do not cover up any openings on the device and do not block these off.

• The electrical socket must be easily accessible so that the power lead can be

disconnected easily, in the case of an emergency.

• The installation and assembly of this device in non-stationary setup locations (e.g. on

ships) must be carried out by specialist companies / electricians, provided they

guarantee the prerequisites for the safe use of this device.

Remove the device out of the carton, remove the packaging material, shovel and

measuring container.

The packaging protects the device against damages during transit. The packaging

materials are selected in accordance with environmentally compatible and recycling-

related points of view and can therefore be recycled. Returning the packaging back to the

material loop saves raw materials and reduces the quantities of accumulated waste. Take

any packaging materials that are no longer required to "Green Dot" recycling collection

points for disposal.

► If possible, keep the original packaging for the device for the duration of the guarantee

period of the device, in order that the device can be re-packaged properly in the event

of a guarantee claim.

In order to ensure the safe and trouble-free operation of the device, the following

instructions must be observed for the electrical connection:

• Before connecting the device, compare the connection data (voltage and frequency) on

the rating plate with those of your electrical network. This data must agree in order that

no damages occur in the device. If in doubt, ask your qualified electrician.

caso AirVital Pro

Please note

Table des Matières

5410