Publicité
FINAL ASSEMBLY
1. Close the electrical enclosure using the electrical enclosure cover, set aside in "Access the Electrical Enclosure".
Note: Leaving too much Field Wire in the enclosure could prevent it from closing properly and may cause damage to the internal
components.
2. Using the provided #8 screws [203-1538] attach an adjustable button receiver [211-1362] to each bracket. The screw head on the
button receiver must be facing down.
3. The orientation of the mirror and light can be adjusted by moving the button to the opposite hole. Remove the #6 Screw holding
the button in place by turning it counterclockwise (3A). Attach the Button to the second hole but inserting and turning the #6 Screw
clockwise (3B). Repeat these steps for the other button.
1
© 2020 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
2
14
3A
205-3304
203-1538
Button
[211-1351]
3B
205-3304
203-1538
Part no. 209-1330 01/06/21
Vesper Edgeline Lights
Publicité
Chapitres
