Conrad 85 63 40 Notice D'emploi page 31

The monitor must be in AV mode to play back the image of the DVD player.
Select the desired power source for the monitor.
Power connection via the provided 12/24 V/DC car adapter:
- Connect the 12/24 V/DC car adapter to the power connection of the monitor.
- Plug the 12/24 V/DC car adapter into the vehicle cigarette lighter socket. The red
LED on the 12/24 V/DC plug lights up.
- Press the "POWER" button on the monitor or the "POWER" button
remote control. The red LED on the "POWER" button on the monitor lights up.
Connecting the monitor to the vehicle's power source using a cable:
- Select the installation path for the connecting cable from the monitor's place of
installation to the vehicle's fuse box.
- Look for the 12V+ clamp in the vehicle's fuse box. The clamp only provides pow-
er when the ignition key is in the ignition lock and turned into the first position.
- Connect the red wire of the connecting cable to this clamp.
- Connect the black wire of the connecting cable to earth.
Functional check
You can check if all cables have been properly connected by:
- reconnecting the battery.
- by inserting the ignition key into the ignition lock and turning it into the first
position.
- connecting the monitor cable to the monitor.
- pressing the "POWER" button on the monitor or the "POWER" button
remote control. The red LED on the "POWER" button on the monitor lights up.
If the camera signal is not received (also see information on channel selection), "NO
SIGNAL" is displayed on the monitor.
on the
on the
31